Feature

Type RSCI is a centrifugal lift off sprag type freewheel with the inner race rotating. Only the inner race is designed for freewheeling. It is a non self- supported type.

Bearings must be provided to ensure concentricity of the inner and outer races and support axial and radial loads, as shown overleaf. Concentricity and run-out limits must be observed. The RSCI type accepts all types of lubricant currently used in power transmission equipment. It is possible to mount these freewheels directly in gear-boxes without separate lubrication. An oil mist is generally sufficient. Grease lubrication may be acceptable if the unit works mostly in overrunning condition, as on E-motors.

When used as a backstop, it must be checked that the overrunning speed will not go below the minimum speed given in the caracteristics table. Please refer to page 78 (RSCI 180–300) for further information.
 

NOTES

1) T _max = 2 × T _KN

2) This maximum allowable torque transmission speed n max must not be exceeded when transmitting torque

3) This minimum allowable overrunning speed ni imin should not be reduced under continuous operation.

Possible reduction of this minimum speed on request

4) Inner race overruns

Keyway to DIN 6885.1

5) Tolerance +1

Cover F8 must be ordered separately

MOUNTING EXAMPLE

Product Display