Deep groove ball bearing

RIZ...G5G5 Blackstop Clutch Freewheel Bearing

Product information

INTRODUCTION

RIZ...G5G5 Backstop Clutch Freewheel Bearing

Feature

Types RIZ..G1G2/G7G2, RINZ..G5G5 are centrifugal lift off sprag type freewheels with the inner race rotating. Only the inner race is designed for freewheeling.

These are self-contained units designed for overrunning clutch applications. Typically used in crawl drives, where the overrunning speed is high but the drive speed is low and does not exceed the maximum driving speed specified in the table. They are type RIZ, RINZ (» see page 84 for more information) equipped with G type covers featuring a grease pocket and contact free seal. When ordered complete, the unit is delivered grease lubricated, ready for either horizontal or vertical installation.

Type	Size		Speeds				Number			Weight
RIZ RINZ	d^H7	T_KN¹⁾	n_max²⁾	n_imin³⁾	n_imax⁴⁾	D_h7	z	L₁	L	G1
	[mm]	[Nm]	[min-1 ]	[min-1 ]	[min-1 ]	[mm]		[mm]	[mm]	[kg]
	30	375	290	700	9000	100	6	68	43	3.9
	35	550	280	670	8500	110	6	74	45	4.9
	40	800	260	630	7500	125	6	86	53	7.5
	45	912	255	610	6700	130	8	86	53	7.8
	50	###	235	560	6000	150	8	94	64	10.8
	60	###	210	510	5300	170	10	114	78	16.8
	70	###	195	470	4000	190	10	134	95	20.8
	80	###	155	375	4000	210	10	144	##	27
	90	###	145	350	3000	230	10	158	##	40
	100	###	140	340	2400	270	10	182	##	67
	130	###	130	320	2400	310	12	212	##	94

NOTES
1) T _max = 2 × T _KN
» Refer to Selection page 10 to 13
2) This maximum allowable torque transmission speed
n max must not be exceeded when transmitting torque
3) This minimum allowable overrunning speed n imin
should not be reduced under continuous operation.
Possible reduction of this minimum speed on request
4) Inner race overruns

MOUNTING EXAMPLE